Front Panel Menu Reference SCPI Command
Select Transient\Arb\Config\CD.
Enter a Dwell time in seconds. Selecta point number and
enter a value for that point. Then press Select.
To configure a voltage CD Arb of 10 points, use:
ARB:VOLT:CDW:DWEL 0.01,(@1)
ARB:VOLT:CDW 1,2,3,4,5,6,7,8,9,10,(@1)
Step 3. Configure the final steps common to all Arbs. Refer to Configuring Steps Common to all Arbs at
the end of this section.
Configuring an Arb Sequence
Arb Sequences can only be programmed using SCPI commands. However, individual
Arbs within the sequence can be programed from the front panel and with SCPI
commands as previously discussed.
The Arb Sequence allows multiple and different Arbs to run one after another is succession. Any of the
standard Arb types, except for constant-dwell Arbs, can be included in the Arb sequence. All Arbs in
the sequence must be of the same type; either voltage, current, resistance, or power.
As with single Arbs, each Arb in the sequence has its own repeat count, can be set for dwell or trigger
pacing, and can be set to repeat continuously. Note also that a repeat count can be set for the entire
sequence, and it can also be set to repeat continuously.
Sequence steps must be specified sequentially. The last value in the parameter list is the sequence
step number. When a step is added, all Arb parameters must be entered.
The following figure illustrates a sequence comprised of a pulse Arb, a ramp Arb, and a sine Arb. The
repeat count value indicates how many times each Arb repeats before moving to the next type.
4 Operating the Power System
126 Keysight N6700C Operating and Service Guide
To Next Page
Loading...
