Step Command
[SOURce:]STEP:TOUTput 0|OFF|1|ON, (<@chanlist>)
[SOURce:]STEP:TOUTput? [MIN|MAX,] (<@chanlist>)
Specifies whether a trigger out is generated when a transient step occurs. A trigger is generated when
the state is on (true).
Parameter Typical Return
0|OFF|1|ON , *RST OFF 0or1
Sets the step trigger signal to ON: STEP:TOUT ON
l The query command returns 0 if the trigger signal will NOT be generated (OFF) when a step
occurs, and 1 if a trigger signal will be generated (ON) when a step occurs.
5 SCPI Programming Reference
290 Keysight N6700C Operating and Service Guide
To Next Page
Loading...
