[SOURce:]ARB:CURRent:CONVert (@<chanlist>)
[SOURce:]ARB:VOLTage:CONVert (@<chanlist>)
[SOURce:]ARB:POWer:CONVert (@<chanlist>)
[SOURce:]ARB:RESISTANCE:CONVert (@<chanlist>)
Converts the specified arbitrary waveform to a list of points in the user-defined current, voltage,
power, or resistance Arb types. This makes it possible to modify/edit one of the "standard" arbitrary
waveforms.
To use this command you must first specify an Arb shape and type using the ARB:FUNCtion:SHAPe
and the ARB:FUNCtion:TYPE commands.
Parameter Typical Return
(none) (none)
The following commands convert the ARB previously specified on channel 1:
ARB:CURR:CONV (@1)
ARB:VOLT:CONV (@1)
ARB:POW:CONV (@1)
ARB:RESISTANCE:CONV (@1)
l If the Arb function is set to User-Defined or None, the command is ignored.
[SOURce:]ARB:FUNCtion:SHAPe <shape>, (@<chanlist>)
[SOURce:]ARB:FUNCtion:SHAPe? (@<chanlist>)
This command replaces the previous ARB:FUNCtion command and should be used in
new applications. ARB:FUNCtion is used for backward compatibility.
Sets the shape of the arbitrary waveform generator as follows:
STEP Specifies a step
RAMP Specifies a ramp
STAircase Specifies a staircase
SINusoid Specifies a sine wave
PULSe Specifies a pulse
TRAPezoid Specifies a trapezoid
EXPonential Specifies a exponential waveform
UDEFined Specifies a user-defined waveform
CDWell Specifies a constant-dwell waveform
SEQuence Specifies a sequence of arbitrary waveforms
NONE Specifies no arbitrary waveform
5 SCPI Programming Reference
186 Keysight N6700C Operating and Service Guide
To Next Page
Loading...
