Keysight N6700C Series - Page 287

Parameter Typical Return
A decimal value that corresponds to the binary-weighted sum of the bits
in the register.
<bitvalue>
Enable bit3 and 4 in the enable register: STAT:OPER:ENAB 24, (@1)
l *CLS does not clear the enable register, but does clear the event register.
STATus:OPERation:NTRansition <value>, (@<chanlist>)
STATus:OPERation:NTRansition? (@<chanlist>)
STATus:OPERation:PTRansition <value>, (@<chanlist>)
STATus:OPERation:PTRansition?
Sets and queries the value of the NTR (Negative-Transition) and PTR (Positive-Transition) registers.
These registers serve as a polarity filter between the Operation Condition and Operation Event
registers.
When a bit in the NTR register is set to 1, then a 1-to-0 transition of the corresponding bit in the
Operation Condition register causes that bit in the Operation Event register to be set.
When a bit in the PTR register is set to 1, then a 0-to-1 transition of the corresponding bit in the
Operation Condition register causes that bit in the Operation Event register to be set.
STATus:PRESet sets all bits in the PTR registers and clears all bits in the NTR registers.
Parameter Typical Return
A decimal value that corresponds to the binary-weighted sum of the bits
in the register.
<bitvalue>
Enable bit3 and 4 in the NTR register: STAT:OPER:NTR 24, (@1)
Enable bit3 and 4 in the PTR register: STAT:OPER:PTR 24, (@1)
l If the same bits in both NTR and PTR registers are set to 1, then any transition of that bit at the
Operation Condition register sets the corresponding bit in the Operation Event register.
l If the same bits in both NTR and PTR registers are set to 0, then no transition of that bit at the Oper-
ation Condition register can set the corresponding bit in the Operation Event register .
l The value returned is the binary-weighted sum of all bits set in the register.
STATus:PRESet
Presets all Enable, PTR, and NTR registers.
Operation register Questionable register Presetsetting
STAT:OPER:ENAB STAT:QUES:ENAB all defined bits are disabled
STAT:OPER:NTR STAT:QUES:NTR all defined bits are disabled
STAT:OPER:PTR STAT:QUES:PTR all defined bits are enabled
Keysight N6700C Operating and Service Guide 287
5 SCPI Programming Reference