Query Errors (these errors set Standard Event Status register bit #2)
-400 Query Error
Generic error query
-410 Query INTERRUPTED
A condition causing an interrupted query error occurred.
-420 Query UNTERMINATED
A condition causing an unterminated query error occurred.
-430 Query DEADLOCKED
A condition causing a deadlocked query error occurred.
-440 Query UNTERMINATED after indefinite response
A query was received in the same program message after a query indicating an indefinite response
was executed.
Self-test Errors (these errors set Standard Event Status register bit #3)
202 Self-test Fail Aux Adc 0 expected <n1> to <n2>, measured <n3>, chan <n4>
Auxiliary ADC failed. n1 and n2 are the expected limits. n3 is the measured value. n4 is the channel
location of the failed module.
202 Self-test Fail DACs 0 expected <n1> to <n2>, measured <n3>, chan <n4>
Both voltage and current DACs are at zero. n1 and n2 are the expected limits. n3 is the measured
value. n4 is the channel location of the failed module.
202 Self-test Fail DACs 1 expected <n1> to <n2>, measured <n3>, chan <n4>
Voltage DAC is at zero; current DAC is at full scale. n1 and n2 are the expected limits. n3 is the
measured value. n4 is the channel location of the failed module.
202 Self-test Fail DACs 2 expected <n1> to <n2>, measured <n3>, chan <n4>
Voltage DAC is at full scale; current DAC is at zero. n1 and n2 are the expected limits. n3 is the
measured value. n4 is the channel location of the failed module.
202 Self-test Fail DACs 3 expected <n1> to <n2>, measured <n3>, chan <n4>
Both voltage and current DACs are at full scale. n1 and n2 are the expected limits. n3 is the measured
value. n4 is the channel location of the failed module.
5 SCPI Programming Reference
326 Keysight N6700C Operating and Service Guide
To Next Page
Loading...
