7-12 Keysight N9912A Service Guide
Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
7-
Figure 7-6 Separating the Front and Rear Cases (3)
Replacing the Battery Cable
1. Separate the front and rear cases. See “Separating the Front and Rear
Cases” on page 7-9.
2. Note the orientation of the cable for installation of the new cable, then,
using a small flat-blade screwdriver to move the cable connector, release
the retention clips on the cable connector and remove the cable from the
rear case.
To Next Page
Loading...
