Keysight U3402A - Measure AC and DC Current on a Rectification Circuit

3 Application Tutorial
68 Keysight U3402A User’s and Service Guide
5 Press . Use
and to select autoranging or manual ranging for
the primary and secondary display. The ranging will be the same for both
displays.
Measure AC and DC Current on a Rectification Circuit
A single measurement for both AC current and DC current can be displayed
through both display while testing a rectifier circuit.
1 Connect the red and black test leads to the input terminal and probe the test
points as shown in Figure 3-2.
Figure 3-2 Terminal connection when measuring AC and DC current on a
rectification circuit
NOTE
– Press to disable the secondary display.
– Press to select the suitable range if DCV+ACV ripple is above the scale
of the current range.
WARNING
– Make sure you select the correct input terminal according to the input range
used.
– Do not apply more than 12 A to the A input terminal to avoid the multimeter
from damage.
AC/DC
current
source
+
–