1 Calibration Procedures
102 Keysight U3606B Service Guide
Calibration Error Codes
The following errors indicate failures that may occur during a calibration.
Table 1-34 List of calibration errors
Error code Error message
701 Cal security pads short
702 Cal secured
703 Invalid secure code
704 Secure code too long
705 Cal aborted
706 Cal value out of range
707 Cal signal measurement out of range
708 Cal signal frequency out of range
709 Cal source unfinished
710 EEPROM write failure
720 Cal DCV offset out of range
721 Cal DCI offset out of range
722 Cal RES offset out of range
723 Cal CAP offset out of range
726 Cal RES open out of range
742 Cal checksum failed, DCV corrections
743 Cal checksum failed, DCI corrections
744 Cal checksum failed, RES corrections
745 Cal checksum failed, ACV corrections
746 Cal checksum failed, ACI corrections
747 Cal checksum failed, FREQ correction
748 Cal checksum failed, CAP corrections
To Next Page
Loading...
