Keysight U3606B - Page 13

Keysight U3606B Service Guide 13
List of Figures
Figure 1-1 Test setup for zero offset (short) verification . . . . . . . .27
Figure 1-2 Test setup for DC voltage and AC voltage gain
verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28
Figure 1-3 Test setup for capacitance gain verification . . . . . . . .29
Figure 1-4 Test setup for 2-wire resistance gain verification . . . .30
Figure 1-5 Test setup for 4-wire resistance gain verification . . . .31
Figure 1-6 Test setup for DC current and AC current gain
verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31
Figure 1-7 Test setup for frequency voltage gain verification . . .32
Figure 1-8 Test setup for frequency current gain verification . . . .32
Figure 1-9 Test setup for diode voltage gain verification . . . . . . .33
Figure 1-10 Test setup for constant voltage programming and
readback accuracy verification . . . . . . . . . . . . . . . .34
Figure 1-11 Test setup for constant voltage load and line
regulation verification . . . . . . . . . . . . . . . . . . . . . . .34
Figure 1-12 Test setup for constant voltage noise effect
(peak-to-peak and RMS noise) verification . . . . . .35
Figure 1-13 Test setup for load transient response time
verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .35
Figure 1-14 Test setup for constant current programming and
readback accuracy verification . . . . . . . . . . . . . . . .36
Figure 1-15 Test setup for constant current load and line
regulation verification . . . . . . . . . . . . . . . . . . . . . . .36
Figure 1-16 Test setup for constant current RMS noise effect
verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37
Figure 1-17 Graph of load transient response time for S1 range . .55
Figure 1-18 SECUR pads location . . . . . . . . . . . . . . . . . . . . . . . . . .70