Required
Tools
Disassembly Instructions
Material Type:
Warning: This drawing format requires special non-standard fonts!!
Make sure the appropriate font files are installed!!!
TT Humanst 521 BT Light
O HelveticaLTStd-Cond
O HelveticaLTStd-LightCond
Concerto Auditorium Seating
Page 1 of 2Rev. 0 P0033-0037
A . Steel B. Plastic
KI · 1330 Bellevue Street · P.O. Box 8100 · Green Bay, WI 54308-8100 · 1-800-424-2432 · www.ki.com
Procedure:
1. Remove the screws holding the seat to the seat support column
and remove the seat assembly.
2. Remove the screws holding the backrest onto the back supports
and remove the backrest assembly.
3. Remove the screws holding the side panels to the seat support
and remove the side panels. Remove the screws holding the up-
per side panel retaining bracket to the column and remove the
bracket.
4. Remove the screws holding the arm cap onto the top of the seat
support column and remove the arm cap.
5. Remove the nuts holding the column onto the floor and remove
the column and lower side panel bracket.
(continued next page)
General Notes:
1. Disassembly time: 15-30 minutes
2. This procedure assumes basic familiarity with hand tools and
furniture terminology: no specialized training is required
3. All materials removed and disassembled shall be sorted and
segregated with like materials and disposed of or recycled
according to recycling availability or waste acceptance
4. For items to be recycled, refer to KI's End of Life Recycling
Matrix and KI's End of Life Recovery Options Matrix, available
at www.ki.com
All fasteners not explicitly tagged or
shown are Material Type A: Steel
SCALE 0.050
SCALE 0.100
Gloves
Safety Glasses
Pry Bar
Philips Screwdriver
Putty Knife
Hex Socket Wrench
Rubber Mallet
Flat Screwdriver
Channel Lock Pliers
Torx Screwdriver
A
A
A
B
B
B
To Next Page
Need help?
General
