KI Concerto - Tools and Construction Requirements; Tools Required for Assembly; Minimum Construction for Upright Installation; Floor Fastener Requirements

Required
Tools
Disassembly Instructions
Material Type:
Warning: This drawing format requires special non-standard fonts!!
Make sure the appropriate font files are installed!!!
TT Humanst 521 BT Light
O HelveticaLTStd-Cond
O HelveticaLTStd-LightCond
Concerto Auditorium Seating
Page 2 of 2Rev. 0 P0033-0037
A. Steel B. Plastic C. Foam D. Fabric E. Cast Iron
KI · 1330 Bellevue Street · P.O. Box 8100 · Green Bay, WI 54308-8100 · 1-800-424-2432 · www.ki.com
Procedure (continued):
6. Remove the backrest shroud from the backrest assembly
and remove the screws holding the backrest support brac-
kets to the back of the backrest. Remove the brackets.
7. Remove the screws holding the seat shroud to the seat and
remove the seat shroud. Remove the screws holding the seat
pivot brackets to the seat and remove the brackets, the pivot
axle and the pivot bushings.
8. Remove the counterweight from bottom of the seat.
Gloves
Safety Glasses
Pry Bar
Philips Screwdriver
Hex Socket Wrench
Rubber Mallet
Flat Screwdriver
Channel Lock Pliers
Torx Screwdriver
A
A
B
C
D
C
D
B
A
A
A
B
B
E
B
B