KI Seminar - Page 16

16
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Seminar
TM
Tables with 4-Wire Power System - Power Modules
Assembly Instructions
Figure
16
tabletop
Nacre In-Surface
Pop-Up power module
with 3-prong plug
Detail J
receptacle hub
shroud
duplex
receptacle
Nacre In-Surface
Pop-Up power module
with 3-prong plug
Nacre
®
In-Surface Pop-Up Power
Module Installation
33. Install the Nacre In-Surface Pop-Up
power module with 3-prong plug
into the mounting hole in the
tabletop per the manufacturer’s
instructions included with the
module (Figure 16).
34. Once the Nacre In-Surface Pop-Up
power module with 3-prong plug is
installed, route the power cord to
the nearest duplex receptacle under
the table and plug the 3-prong plug
end into it (Detail J).