STEERING WHEEL
CONTROLS
STEERING WHEEL CONTROLS
Smart Cruise Control (SCC)*
†6
(continued)
(Type A; buttons located on right side
of Steering Wheel)
REMINDERS:
• Cruise Control button must be ON in order to turn SCC ON/OFF
• SCC can operate when the vehicle is driving faster than 6 mph
• SCC is activated when ignition is turned on. Speed will need to be reset when ignition is
cycled on
• SCC is turned ON again when the ignition is cycled off, then on again. The speed setting will
need to be reset when ignition is cycled
• SCC is also canceled when the driver’s door is opened, gear shift is changed out of D (Drive),
EPB is activated and various other conditions. See Owner’s Manual for other conditions
• In standard Cruise Control, the driver needs to manually assess the distance from other
vehicles as the system will not automatically apply brakes
• If SCC is left on, it can be activated inadvertently. Keep the system off when not in use to
avoid setting a speed that the driver is not aware of
• When following a vehicle, the system will automatically adjust your cruise speed based on
the vehicle detected in front
To change the Cruise Control mode from SCC to standard Cruise Control, press
and hold button
D
. Repeat to switch modes again (SCC must not be activated to
change modes).
If your vehicle speed is between 5~20 mph when you press the Driving Assist
CRUISE button, the Smart Cruise Control speed will be set to 20 mph
When following a vehicle, the system will automatically adjust your cruise speed
based on the vehicle detected ahead. If the vehicle detected remains at a standstill
for more than 3 seconds, the system will disable.
QUICK TIPS
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS. *IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
25
REMINDER: Standard Cruise Control is a part of Smart Cruise Control (SCC)* and can be set
as the operating mode. To switch from SCC to Standard Cruise Control, press and hold the
CRUISE button (the SCC system must not be activated to change modes). Repeat to switch
back to SCC mode
D
Driving Assist CRUISE button: Press to turn the Cruise Control
ON/OFF
E
RES
+
button: Press up to resume or increase cruising speed
SET- button: Press down to set or decrease cruising speed
F
CANCEL button: To cancel Cruise Control, do one of the following:
• Press the brake pedal
• Press the CANCEL button
G
Switch Modes*: To switch between standard Cruise Control and
Smart Cruise Control, press and hold for more than two seconds
Cruise Control (CC)
†21
•
• Cruise Control is designed to function at above approximately 20 mph
• The Cruise Control system will not activate until the brake pedal has been
depressed at least once after ignition ON or engine starting
QUICK TIPS
See section 5 in the Owner’s Manual for more information.
RES
SET
CNCL
+
–
CRUISE
OK
RES
SET
CNCL
+
–
CRUISE
OK
RES
SET
CNCL
+
–
CRUISE
OK
RES
SET
+
–
CRUISE
OK
RES
SET
+
–
CRUISE
OK
RES
SET
+
–
CRUISE
OK
CANCEL
OK
RES
SET
+
–
CRUISE
CANCEL
OK
MODE
D
FG
E
To Next Page
Loading...
