Features of your vehicle
344
Windows
Pressing or pulling up the power window
switch momentarily to the second detent
position (6) completely lowers or raises
the window even when the switch is
released. To stop the window at the
desired position while the window is in
operation, pull up or press down and
release the switch.
If the power window does not operate
normally, the automatic power window
system must be reset as follows:
1. Press the ENGINE START/STOP But
-
ton twice to the ON position.
2. Close the driver's and front passen
-
ger’s window and continue pulling up
the driver’s power window switch for
at least 1 second after the window is
completely closed.
Automatic reversal (for Auto up/
down window)
If the upward movement of the window
is blocked by an object or part of the
body, the window will detect the resis
-
tance and will stop upward movement.
The window will then lower approxi
-
mately 11.8 in. (30 cm) to allow the
object to be cleared.
The distance may vary based on the size
or position of the window. If the window
detects the resistance while the power
window switch is pulled up continuously,
the window will stop upward movement
then lower approximately 1 in. (2.5 cm).
If the power window switch is pulled up
continuously again within 5 seconds
after the window is lowered by the auto
-
matic window reversal feature, the auto
-
matic window reversal will not operate.
The automatic reverse feature for the
driver’s and front passenger’s window is
only active when the “auto up” feature is
used by fully pulling up the switch. The
automatic reverse feature will not oper
-
ate if the window is raised using the half
-
way position on the power window
switch.
Always check for obstructions before
raising any window to avoid injuries or
vehicle damage. If an object less than
0.16 in. (4 mm) in diameter is caught
between the window glass and the
upper window channel, the automatic
reverse window may not detect the
resistance and will not stop and reverse
direction.
The automatic reverse feature doesn’t
activate while resetting power window
system. Make sure body parts or other
objects are safely out of the way before
closing the windows to avoid injuries or
vehicle damage.
Do not install any accessories in the
vehicle that extend into the open win
-
dow area. Such objects could prevent
the automatic reverse feature from
functioning.