57
4
4
Features of your vehicle Mirrors
Outside rearview mirror
Be sure to adjust the mirror angles
before driving.
Your vehicle is equipped with both left-
hand and right-hand outside rearview
mirrors. The mirrors can be adjusted
remotely with the remote switch. The
mirror heads can be folded back to pre
-
vent damage during an automatic vehi
-
cle wash or when passing through a
narrow street.
The right outside rearview mirror is con
-
vex. Objects seen in the mirror are closer
than they appear.
Use your interior rearview mirror or
direct observation to determine the
actual distance of following vehicles
when changing lanes.
Rearview mirror
Do not scrape ice off the mirror face; this
may damage the surface of the glass. If
ice should restrict the movement of the
mirror, do not force the mirror for
adjustment. To remove ice, use a deicer
spray, a sponge or soft cloth with very
warm water.
If the mirror is jammed with ice, do not
adjust the mirror by force. Use an
approved spray de-icer (not radiator
antifreeze) to release the frozen mecha
-
nism or move the vehicle to a warm
place and allow the ice to melt.
Mirror adjustment
Do not adjust or fold the outside rear
-
view mirrors while the vehicle is moving.
This could result in loss of control.
Adjusting outside rearview mirror
The electric remote control mirror switch
allows you to adjust the position of the
left and right outside rearview mirrors.
To adjust the position of either mirror,
press the R or L button (1) to select the
right side mirror or the left side mirror,
then press a corresponding point (▲) (2)
on the mirror adjustment control to posi
-
tion the selected mirror up, down, left or
right.
After adjustment, press the R or L button
again to prevent the inadvertent adjust
-
ment.
Outside mirror
僅 The mirrors stop moving when they
reach the maximum adjusting angles,
but the motor continues to operate
while the switch is pressed.
Do not press the switch longerthan
necessary, the motormay be dam
-
aged.
僅 Do not attempt to adjust the outside
rearview mirror by hand. Doing so
may damage the parts.
僅 When the mirror control, press exactly
“▲” (2) marking area. Otherwise, the