11
3
3
Safety features of your vehicle Seat
Driving Position Memory System is the
facility that enables driver’s seat, steer
-
ing wheel, outside rear view mirrors and
head-up display (HUD) to be controlled
with a simple button operation, which
allows a driver to recall memorized driv
-
ing positions to suit your preferences.
僅 Driver’s seat/Steering Wheel /Exterior
mirrors: position
僅 Head up Display (HUD): position
Never attempt to operate the driver
position memory system while the vehi
-
cle is moving.
This could result in loss of control, and
an accident causing death, serious
injury, or property damage.
Storing positions into memory
using the buttons on the door
Storing driver’s seat positions
1. Press the Parking button while the
ENGINE START/STOP button is ON.
2. Adjust the driver’s seat and outside
rearview mirror and Head up display
comfortable for the driver.
3. Press SET button on the control panel.
The system will beep once.
4. Press one of the memory buttons (1 or
2) within 5 seconds after pressing the
SET button. The system will beep
twice when memory has been suc
-
cessfully stored.
Recalling positions from memory
1. Press the Parking button while the
ENGINE START/STOP button is ON.
2. Press the desired memory button (1 or
2). The system will beep once, and
then the driver's seat position, outside
rearview mirror position, Head Up Dis
-
play (HUD) position (if equipped) will
automatically adjust to the stored
positions.
While recalling the stored positions,
pressing one of the control buttons for
the driver's seat, outside rearview mirror,
or Head Up Display (HUD) position (if
equipped) will cause the movement of
that component to stop and move in the
direction that the control button is
pressed.
Use caution when recalling the adjust
-
ment memory while sitting in the vehicle.
Push the seat position control switch to
the desired position immediately if the
seat moves too far in any direction.
Easy access function (if
equipped)
To provide easier entry to or exit from
the vehicle for a driver, the driver’s seat
will be adjusted backwards as far as the
distance set by User Setting on the
Instrument Panel. This occurs when the
driver’s door is opened and the ENGINE
START/STOP button is Off with the shift
lever in the P position. If, however, the
distance between the front seat and
back seats are too close, the driver’s seat
could fail to adjust itself backwards.
The steering wheel moves to the top.
With the steering wheel moving as far as
top and as far as forward to a driver on a
regular basis (once every 100 ignitions
switched on), the steering wheel identi
-
fies and adjusts its location by itself.
The driver’s seat and steering wheel will
move back to its original position when a
driver closes a driver’s door with a smart
key in his pocket and the ENGINE
START/STOP button is in OFF or in ACC.
To Next Page
Loading...
