Maintenance
647
Light bulbs
8. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
9. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly. Push the
socket into the assembly and turn the
socket clockwise.
10.Install the rear combination lamp
assembly to the body of the vehicle.
11.Install the service cover by putting it
into the service hole.
Rear turn signal lamp (bulb type)
bulb replacement
1. Open the tailgate.
2. Open the service cover.
3. Loosen the lower light assembly
retaining screw with a cross-tip screw
-
driver or spanner.
4. Remove the garnish (1) on the top of
the rear combination lamp and loosen
the 1 screw (2) on the top.
5. Remove the rear combination lamp
assembly from the body of the vehi
-
cle.
To Next Page
Loading...
