3
1m cable
The remote bar mounting clamp may be installed to either the left or right side on the back of the remote.
Use the included remote mounting plate to perform a custom, fl ush installation of the remote. Be careful
not to drill into wiring or vehicle mechanisms. You are solely responsible for safely and securely mounting
the unit and remote. Use the cut-out template below to assist in the installation.
Use the included 1.5m
remote extension cable if
necessary
Width: 86mm
Height:
41mm
Depth: 18mm
2016 PXiBT100.2 Rev G.indd 32016 PXiBT100.2 Rev G.indd 3 12/8/2015 11:35:28 AM12/8/2015 11:35:28 AM
To Next Page
Loading...
