23 24
Press Up or Down button to view past data.
Pressing the Up button shows data of the previous
memory number (old data). Pressing the Down
button shows data of the next memory number
(new data).
Press and hold the Power button. When
"Lumitester" is displayed and it is ready for
measurement after countdown.
4-3. Measurement data check
• The measurement data are automatically saved up to 2000 items and can be checked
by the product.
• Connection with a smartphone, tablet, and/or PC allows automatic loading of
measurement data to save in the cloud.
• After loading the data and selecting a measurement target for the measurement data,
pass/fail judgment of the data can be performed.
5 Product Setup
You can congure the product settings.
Press and hold the Power button for 5 seconds or longer and go to the setup
menu.
Pressing the Up or Down button switches the setting item.
Select a setup item and press START.
Pressing the Power button terminates the setup and the screen returns to the
measurement screen.
Setup Menu
• Normally memory data is not erased while the power is o. However, when the
measurement is continued with low battery level, or when the batteries are removed
while the power is on, the memory data may be erased. We are not responsible for
damage caused when memory data is erased.
If the number of data items exceed 2000, data are overwritten from the oldest one.
Use the Application or PC Software to save data to a smartphone, tablet, and/or PC, or
clear data as needed.
#0004
2017/11/20 13:15
#0003
1234
#0002
999999
Caution
BLE Pairing Mode
Connected 1
Temperature
Compensation
Initialization
No
Yes
(Temperature compensation setting)
(Self-diagnosis)
Connection to 2nd or later
smartphone/tablet
(Restoration to factory setting)
Self-check
(Switch sensitivity adjustment)
Contrast
10
(Display contrast adjustment)
Switch
sensitivity
3
(Product information)
Information
1901 05313 0001S
Ver.FW100 BLE100
(Measurement data deletion)
Data Clear
No
Yes
To Next Page
Loading...
