Kikkoman Lumitester Smart - How to Insert Batteries; Bluetooth ON;OFF Switching

9 10
Battery holder and Bluetooth ON/OFF switch are located inside the battery cover.
The factory shipment setting of the Bluetooth ON/OFF switch is OFF.
To link the Application with a smartphone and/or a tablet, set the Bluetooth
ON/OFF switch ON.
Connection with a smartphone, tablet, and/or PC allows automatic
synchronization of time and date and timestamping of measurement data.
 Press "PUSH" to deploy the stand.
 Press the mark on the battery cover to remove the cover.
Insert two new size AA alkaline batteries or two charged size AA nickel-hydride
batteries, paying attention to polarities.
 Attach the battery cover again.
3-1-3. How to insert batteries
3-1-4. Bluetooth ON/OFF switching
To open/close the battery cover
• Radio frequency bands and communication methods that can be used are dened for
each country. In some countries, registration of wireless devices may be mandatory.
Refer to the website below for countries where Bluetooth can be used.
http://biochemifa.kikkoman.co.jp/e/support/dl/smart
In a country not listed below, set the Bluetooth switch OFF.
• Bluetooth cannot be used to connect to a PC. Please use the provided USB cable.
Caution
Place the batteries
Replacement of batteries
5 seconds after remaining battery amount is displayed
with low battery, the power is automatically turned o.
Replace the batteries.
After removing the batteries, the clock count
continues for 60 seconds.
Please replace the batteries within 60 seconds.
 If Bluetooth is not used, slide the Bluetooth ON/OFF switch to OFF.
The Bluetooth is OFF unless Bluetooth ON is indicated on the display unit.
• Do not mistake the polarities of batteries.
• Do not mix batteries of dierent manufacturers or models, or new and used batteries.
• Do not use an alkaline battery after its validity date has expired.
• Follow the instruction manual for the batteries used.
• Size AA batteries back up the clock of the product. In cases when the batteries are
dead or when the batteries are removed while the power is on, the clock may be
initialized. In this case, adjust the clock.
• Conform to disposal regulations established by local governments when disposing of
batteries.
• Remove the batteries when the product is to be stored for an extended period of time.
Failure to do so may cause liquid leak and burst.
ONOFF
#0004
Caution
Bluetooth ON/OFF
switch
Battery holder