7 8
3 Setup
• Do not swing the product holding the strap.
Failure to do so may cause malfunction or poor precision for measurements.
Attach the strap as shown below.
Do not apply too much
force to the stand
and/or measurement
chamber cover, or move
the product while they
are open. The stand
and/or the
measurement chamber
cover may be damaged.
Do not drop nor apply
excess impact.
Failure to do so may
cause malfunction or
poor precision for
measurements.
Perform measurement
in upright position.
Otherwise failure or low
measurement precision
may occur due to
reagent leakage.
Do not move the
product during
measurement.
Otherwise measurement
error may occur.
Be sure to remove the reagent after measurement.
Failure to do so may lead to liquid leak.
Do not use nor store the product in locations subject to
large variations in temperature.
Do not use nor store the product in locations directly
exposed to wind from air-conditioning equipment.
Allow the product to stand for 30 minutes or longer at
room temperature before use when the product is moved
from a hot or cold location.
Otherwise measurement error may occur.
[About disposal]
Conform to disposal regulations established by your local government when disposing
of the product and accessories.
3-1. Prepare the product
3-1-1. How to attach the strap
Press "PUSH" to deploy the stand.
To close the stand, press the lower end of the stand to the original position.
3-1-2. How to use the stand
Caution
• Do not hold the product while the stand is open.
Otherwise the stand may be damaged.
For proper use
Precautions for measurement
Caution
To Next Page
Loading...
