Kikusui PLZ-U Series Operation Manual

Channel
display
Load unit Frame
mnnm
;-*SEQ
*
Fig.
5-8
Editing the
sequence
iNOTEj
•
If you change the operation mode or range while editing a sequence, the sequence
settings
will
be
cleared. If you plan to use the sequence settings again,
save
the
sequence to
the
setup memory and recall it when you n^d it.
4^
Switch
to
sequence mode.
Press the SEQ key
while holding down the SHIFT key (SHIFT + SW ON).
The SEQ key
and SEQ indicator illuminate.
The selected channel number appears on the channel display.
^
Select the step
number.
Press the STEP key and
turn
the rotary
knob
to
show
the
desired step number.
The step
number appears
at
the upper
section
of
the
setting display.
6. Enter the setting.
Press the SET key and turn the rotary
knob to enter the setting.
The setting
display
of
the selected operation mode
appears.
7^
Set the execution time.
Press the
TIME key and turn the rotary knob to set the
execution time.
The execution time display appears.
8^
Repeat steps 5 to
7
as
necessary.
Up
to 255 steps can be entered.
To specify the end a sequence, set the TIME (execution time)
of the last step to
0
.
5-10
Application
Operation
PLZ-U

Kikusui PLZ-U Series Specifications

General

Brand	Kikusui
Model	PLZ-U Series
Category	Control Unit
Language	English