Kikusui PLZ-U Series Operation Manual

Resetting the PLZ-U to factory default settings
L
While holding down the SHIFT key, turn
on the POWER
switch.
Keep holding down the SHIFT key until a beep
is heard.
The power up operation indicated
in section
2.7, “Power Up"
is exe-
cuted, and the settings are
reset to
factory
default.
5.13.1
Factory Default
Settings (General)
Table
5-7
Factory default settings
Item
Factory Default Settings
Relevant
Function
Operation mode
CC
Section
4.3,
“Basic Operation”
Current
range H range
Voltage range H range
CC mode SCT
value
0.000 A
CR mode SET value 0.0 S
CV mode SET value 157.50
V
Switching Function Off
Section
5.3,
“Switching Function”
CC switching level OA
CR switching level
OS
Switching
frequency 1.000 kHz
Switching duty cycle 50.0
%
Slew r^te
Maximum value of H range
Section
5.4,
“Setting the Slew Rate”
Soft start
1.0 ms Section 5.
1 ,
“Soft Start Function”
OCP trip point 1
10 % of the
rated current of H range
Section
4.4,
“Protection Functions and Alarms”OPP trip point
1 10 % of the rated power
of
H
range
UVP trip point OFF
Sequence mode Off
Section
5.6,
“Sequence Function”
Operation mode
CC
Current range H range
Step setting 0.000
A
Step execution
time 0 ms
RPr 1
Key
lock
Off Section
5.8,
“Key
Lock Function”
Load Off
Section
4.2,
“Load On/Off’
Auto load
off
timer
Off
ENTRY Channel
1
Section 3.
1 ,
“Front Panel”INDEP
Off
DISP Voltage
and
current
•
For details on the configuration settings, see section
5.9,
“Configuration
Settings.”
5-32
Application Operation PLZ-U

Kikusui PLZ-U Series Specifications

General

Brand	Kikusui
Model	PLZ-U Series
Category	Control Unit
Language	English