Kikusui PLZ-U Series Operation Manual

2^
Select the
memory
number.
Turn the rotary
knob to
show the number
(0
to
3)
of the memory
to which set-
tings are to be
saved.
3^
To cancel, press
the STORE (SHIFT + RECALL)
key again.
4
Press the ENTER key.
The
settings described
above
are
saved
to the memory.
The STORE key and
STORE indicator turn
ojf.
[N^
•
If settings are
already stored at
the selected memory number, the settings are over-
written.
Recalling the memory
T Press the
RECALL key.
The display
switches to the setup
memory number display.
Z Select the
number of the
memory to be recalled.
Turn the rotary knob
to show the number
(0
to
3)
of the memory to
be recalled.
Z
To cancel,
press the RECALL
key again.
4^
Press
the ENTER key.
The
settings in the
memory are recalled.
•
If a
setup memory is
recalled while the
load is turned on, the
load automatically
turns off.
•
Note that if
you recall a
setup memory, the
current operation mode
and settings
will be
changed.
•
The recall
operation takes up to
2 seconds per channel
depending on the
length of
the sequence
program.
5.13
Factory
Default
Settings
The backup function
of the PLZ-U
retains the current
settings and memory
contents
(ABC preset
memories and setup
memories)
even
when
the POWER
switch is
turned off.
However, you can
carry out the following
procedure to
reset the PLZ-U
to factory
default
settings.
•
For
details on the
factory default
settings, see Table
5-7
and Table
5-8.
•
Use
caution because
the contents of
ABC preset memories
and the setup memo-
ries are
also cleared
when the PLZ-U
is reset to factory
default settings.
PLZ-U
Application
Operation
5-31

Kikusui PLZ-U Series Specifications

General

Brand	Kikusui
Model	PLZ-U Series
Category	Control Unit
Language	English