PLEASE READ THE
FOLLOWING INFORMATION
BEFORE USING YOUR SCALE!
THE FOLLOWING STEPS MUST BE CONSIDERED WHEN USING YOUR SCALE AND TO REAL-
IZE ITS BEST PERFORMANCE. DIGI-STAR SCALES ARE MANUFACTURED TO PROVIDE 1/2%
MAXIMUM ERROR. A GOOD INSTALLATION AND PROPER USE ARE REQUIRED IN ORDER TO
OBTAIN ADVERTISED ACCURACY.
A GOOD INSTALLATION REQUIRES THAT ALL LOAD CELLS ARE PROPERLY INSTALLED WITH
“TOP” ACCURATELY POSITIONED.
OPERATION
TO INSURE + OR -1/2% MAXIMUM ERROR, THE UNIT MUST BE USED AS A STATIONARY
LOAD-OUT WEIGH HOPPER FROM BIN TO TRUCK, FOR EXAMPLE, THE GROUND MUST BE
SMOOTH AND LEVEL WITH MAXIMUM 5” SLOP PER 10 FEET.
TO INSURE + OR -1% MAXIMUM ERROR, THE UNIT MUST BE USED SO THAT ALL WEIGHT
MEASUREMENTS OCCUR ON FLAT SMOOTH GROUND (MAXIMUM OUT OF LEVEL 10” IN 10
FEET) IDEALLY, ALL WEIGHT MEASUREMENTS FOR A FIELD WOULD OCCUR IN THE SAME
SPOT.
WARNING!
ALWAYS DISCONNECT CABLES
FROM SCALE INDICATOR BEFORE
JUMP STARTING ENGINE.
To Next Page
Loading...
