Date and hour :
Use the knob to settle each figures of the date and of the hour, and validate at each time pressing on the
knob. To return to a figure previously validated, press on " ESC ".
Retro-lighting :
It is possible to activate or to deactivate the retro-lighting of the display : by means of the knob choose
"ON", " OFF " or "automatic" and press to validate. To go out of this menu, press on " ESC ".
Contrast :
By the means of the knob, adjust the contrast of the screen from 0 to 7 and validate by pressing on
the knob.
Keys beep :
It is possible to activate or to deactivate the tone of keys. Validate the chosen option by pressing on
the knob.
8
Languages :
By the means of the knob, browse the different available languages and validate pressing on the knob.
Automatic stop :
It is possible to cancel the automatic stop of the device or to settle it. For that purpose, use the scrolling
down knob and choose " OFF " to cancel the automatic stop or choose a value (by slice of 15 minutes).
When you restore data on PC, the automatic stop does not work, but at the end of the load, the
device goes out automatically.
Solenoid valve :
You can activate or deactivate the solenoid valve, that is make an autozero. It is nevertheless strongly
recommended to leave it active.
Before enter in the menu "recording", it is necessary to connect the probes that will be used. Enter in the menu
which you wish to record. Press the key "Recording" (see p. 3) to reach the menu " Datalogger ". At the bottom
of the screen appears the following scrolling down menu:
- New
- Print.
- Delete
It is thus possible to print data, to record or to delete them.
DATA RECORDING, PRINTING AND DELETING
To Next Page
Loading...
