When you connect your probe(s) (see connections p. 3), the screen shows its characteristics. It is possible to
connect 2 probes thermocouple K at the same time. Press then on the knob to enter in the menu temperature,
the measured value is shown in the screen and the following menu appears on the last line (by browsing the
menu by scrolling down the knob):
- Units
- Delta T (only if 2 probes thermocouple K are connected)
To validate a function, press on the knob when the wished function is shown on the screen.
Units :
See p. 5
Delta T :
See p. 5
TEMPERATURE MENU
Units :
Browse the different available units validate pressing on the knob. When
you have the choice between various parameters (velocity and temperature, for example), you have to
validate each unit of measure.
by scrolling down the knob and
SUB-MENUS
Delta T :
When 2 thermocouple K probes are connected, you have the possibility of calculate the Delta T which
corresponds to the difference between the temperature measured by T1 and T2. To come out of this
function, press the touch " ESC ".
Automatic average :
This function allows to calculate the average value that the device measured in an interval of chosen
time. When "Departure" appears on the screen, press on the knob to start the calculation. The screen
registers the sold time. To stop and reach the result, press again on the knob. The results are registered
on the screen: average (s), minimum value (s), maximum value (s), standard deviation(s) as well as the
duration of the calculation. Press on " ESC " to return to the previous page (by pressing on the knob, you
begin a new calculation).
5
To Next Page
Loading...
