23
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION
The chute plugs easily. Snowblower engine is turning too
slowly.
Always have engine at full R.P.M.
when using the snowblower.
Advancing too quickly with vehicule. Reduce speed. Allow snowblower to
ingest snow at its own speed.
Snowblower digs into ground. Ground is not frozen or too soft. Adjust skid shoes lower so they may
better support the snowblower.
Snowblower does not raise
evenly.
Tire pressure uneven from one side to
another.
Verify and adjust tire pressure:
50 p.s.i.
The snowblower’s is not well
balanced.
If it does not raise evenly, follow these
instructions:
Loosen the eight bolts which hold the
push frame.
Lift the engine side of the snowblower
and slide a 2" (approx.) piece of wood
underneath.
Tighten the eight bolts very firmly
(torque to 65 lbs/ft).
If the blower still doesn’t raise evenly,
repeat the procedure using thicker or
thinner pieces of wood depending on
the weight of the engine.
To Next Page
Loading...