7
ASSEMBLY
Grease both ends of the rotation worm (item 1).
Insert the short rotation bushing (item 2) and the long
rotation bushing (item 3) as shown.
Insert the rotation worm with the short bushing in the
sleeve (item 1).
Insert the rotation worm support (item 2) on the long
bushing as shown.
Apply grease on the rotation ring (item 1).
Install the chute (item 2) with four retaining plates
(item 3) as shown.
At the rear left hand corner, secure a retaining plate
(item 3) on top and the rotation worm support (item 5)
underneath with two 1/4 x 3/4" bolts (item 4) and
flange nuts as shown.
Secure the other three retaining plates (item 3) with
six 1/4 x 1/2" bolts (item 6) and flange nuts.
Tighten the bolts firmly.
Install chute
Insert bushings on rotation worm
Install rotation worm
To Next Page
Loading...