Kinco CD622S - Power,Brake and Encoder Cable of Motors

111 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

8

1.3.3 Power,Brake and Encoder cable of Motors

Table of Contents

Default Chapter1
- Table of Contents1
- Contents1
Chapter 1 Product Acceptance & Model Description4
Chapter 2 Precautions and Installation Requirements9
Chapter 3 Interfaces and Wiring of CD2S Driver13
Chapter 4 Digital Operation Panel19
- Introduction19
- Operation on Digital Operation Panel21
  - Example 4-1: Set the Denominator of Electronic Gear Ratio to 10000 with Number System Switching21
  - Example 4-2: Set the Speed to 1000 RPM/-1000 RPM with Separate Regulation of Bits22
Chapter 5 Motor Selection,Trial Operation and Parameter List24
Chapter 6 Operation on Input/Output Ports46
- Digital Input Signals46
- Digital Output Signals53
Chapter 7 Mode Operation58
Chapter 8 Control Performance90
Chapter 9 Communication103
- Transport Protocol103
- Data Protocol104
  - Download(From Host to Slave)104
  - Upload(From Slave to Host)105
Chapter 10 Troubleshooting108
- Alarm Messages108
- Alarm Causes & Troubleshooting109
Chapter11 Appendix110
- Appendix 1: Selection Table for Brake Resistor110
- Appendix 2:Selection Table for Fuse111

Related product manuals

Preview: Kinco CD420

Preview: Kinco CD3 Series

Kinco CD3 Series

Preview: Kinco CD2S Series

Kinco CD2S Series

Kinco CD423-AA-000

Kinco FD423-LA-000

Kinco FD625-PA-000