Kinco FV20 - Page 35

Chapter 6 List of Parameters
73
Function
code
Name Descriptions Unit
Factory
setting
Modif
.
Setting
range
BIT1: Setting frequency(Flick, Not
display in energy feedback mode)
BIT2: Output current (Not display
when VFD stop, Display grid current
input in energy feedback mode)
BIT3: Output voltage (Not display
when VFD stop, Display grid voltage
input in energy feedback mode)
:
BIT0: AI1
BIT1: AI2
BIT2: Keyboard potentiometer
BIT3: DI(Terminal status)
:
BIT0: Output power (Not display
when VFD stop, not display in energy
feedback mode)
BIT1: Output torque (Not display
when VFD stop, not display in energy
feedback mode)
BIT2: Analog close-loop feedback
(%) (Not display in energy feedback
mode)
BIT3: Analog close-loop setting (%)
(Flick, Not display in energy feedback
mode)
:
BIT0: Bus voltage
BIT1: Speed (R/MIN,Not display in
energy feedback mode)
BIT2: Setting speed (R/MIN,Flick,
Not display in energy feedback mode)
BIT3: Line speed
Note: If all the BITs are 0,the drive will
display setting frequency at stop,
display output frequency at operating
and display bus voltage at energy
feedback mode
b4.06 Operating frequency ratio 0.00 99.99 0.01 1.00 O 0 9999
b4.07 Operating speed ratio 0.000 30.000 0.001 1.000 O 0 30000
b4.08
b4.10
Reserved - - - - 0 65535
b4.11 Menu model selection 0: shortcut menu
1: basic menu (reserved)
2: Advanced menu
1 2 X 0 4