Kinetico Drinking Water Filter
with MACguard
®
Undersink Models 7000 and 7500
Installation Instructions
Rev.: 01/2011 Kinetico Incorporated ◆ Corporate Headquarters ◆ Newbury, Ohio 44065 ◆ (440) 564-9111 Product No. 9383H
1
The Drinking Water Filter with MACguard will not make biologically unsafe water safe to drink since
activated carbon will not kill bacteria. When applying the filter to non-chlorinated water supplies,
additional treatment steps may be necessary to assure the water’s bacterial makeup is compatible with
activated carbon final treatment.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
NOTE: Read all steps, guides and rules carefully before installing and using the Kinetico
Drinking Water Filter with MACguard.
PRE-INSTALLATION CHECKLIST
Before starting installation, check the contents of the box for the following components: See Figure 1
▶Drinking water faucet assembly*, consisting of:
• Faucet base assembly (1)
• Faucet spout (1)
• Small black rubber gasket (1)
• Chrome escutcheon (1)
• Large black rubber gasket (1)
• Black locating washer (1)
• Metal washer (1)
• 9/16” brass nut (1)
▶MACguard head with bracket (1).
▶Taste and odor reduction cartridge Product No. 9306B for
Model 7000 (1).
▶Lead, VOC, and cyst reduction cartridge Product No. 9308A
for Model 7500 (1)
▶Decorative cover with PureMometer
®
indicator window (1)
▶Tubing hook-up kit, consisting of:
• 5/8” bracket mounting screws (2)
• 1/4” tube x 1/4” tube faucet connector (1)
• 3/8” tube x 3/8” tube x 1/4” tube tee (1)
• 1/4” NPT x 1/4” tube elbow (1)
(Model 7500 uses flow control elbow)
• 1/4” NPT x 1/4” tube elbow shutoff valve (1)
• 1/4” O.D. tubing (not pictured)
Figure 1. Typical Package Contents
* Included with certain models only.
To Next Page
Need help?
General
