Operating Instructions
3. Install the battery.
Flat slide the battery into place until the latch returns to the upper position along with a
audible sound .
4. Connect the AC power to Kingon P2 .
The green LED on the power adapter will be on and the concentrator will generate a
sound of beep.
Power supply is not waterproof.
Do not disassemble the power supply.
Do not place anything in the power supply port other than
the supplied wall cord. Avoid the use of electrical extension
cords with the
Kingon P2
.
When the power is disconnected from the AC outlet,
disconnect it from the concentrator to avoid unnecessary
battery discharge.
To Next Page
Loading...
