Kingon P2 - Page 22

Operating Instructions
19
5. Join the nasal c annula to the nozzle fitting by end connector.
Nozzle fitting is located on the top side of the Kingon P2
near the pre-filter .
Connect a nasal cannula to the nozzle fitting.
6. Switch on Kingon P2 by short pressing the ON/OFF Button.
Pressing the ON/OFF button for one second,a sound of beep and the indicator light’s
flashing will turn on.
“ Welcome” will appear on the display while the concentrator starts up. The display will
indicate the selected flow setting and power condition. A two-minute warm up time will
initiate . During this period the oxygen concentration is building to but may not have
reached specification. Under special conditions ,longer warm up time may be
necessary ,such as a extremely cold temperature of storage or operation of Kingon P2.
CAUTION
Ensure that the cannula is routed to prevent it from being
pinched or kinked to avoid a disruption of oxygen flow.
CAUTION
Disposable usage for the cannula.
CAUTION
Oxygen concentration may not reach specification during the
one-minute warm up time.
CAUTION
Kingon P2 will enter mandatory Auto pulse mode after 30
seconds of starting up and lasts for 30 seconds .No
inhalation will work during the 30 seconds .