13. Charging
1. Connect the USB power cable into the USB power port of D4 Dash Cam, then plug the car
charger into the cigarette lighter of your car.
Do NOT connect the camera to PC for charging. Instead use the 110V wall outlet.
The device will start up automatically and record as soon as power supplied, and the device will
save the last video file and power off automatically after cutting the power supply.
2. Turning your camera ON/OFF
Auto Power ON: KINGSLIM D4 is designed to turn ON automatically when it receives power,
i.e. when the car engine is started.
Auto Power OFF: The camera is also pre-configured to turn itself OFF automatically within few
seconds when the power gets disconnected, i.e. when the car key is turned to
LOCK position.
3. Note:
Some trucks/car’s 12V cigarette outlet is always HOT, which means it provides constant
power even when the car is turned off and locked. If this is the case for your vehicle, the auto
ON/OFF feature will not work. And if you leave the camera continuously recording when the
car is turned off, the it will drain your car/truck’s battery and you might not have enough
power to start your car for next time. To remedy this situation, you can do one of the two
options:
① Hardwire your dash cam to your car’s fuse box with KINGSLIM 3 lead auto trigger
hardwire kit. Visit www.kingslim.net to purchase one separately.
② Change the connection in the fuse box for your 12V outlet socket which only supplies
power when car key is turned to ACC or ON position.
RST
Car cigarette lighter socket Car cigarette lighter plug D4 Dash Cam
13
To Next Page
Loading...
