To use the reversing function, please install the rear camera near the license plate, then connect
the red wire of the rear camera extension cable to the positive lead of the vehicle reversing lamp.
Reversing light
Reversing light positive pole
Rear camera connector
Rear camera
Note:
① When connecting the rear camera with the extension cable, please refer to the details below.
② Please clean the position to ensure the adhesive quality before installing the rear camera.
③ Please clean the rear windshield regularly to ensure the image quality if you choose to install
the rear camera on the rear windshield.
④ If you choose to install it near the license plate, you can use adhesive stickers or screws for
fixing.
⑤ Please use the original extension cable and rear camera. If you replace the rear camera with
product of other brands, the effect may be affected and the machine may be damaged.
⑥ Check the interface, the connecting wire and the rear camera interface and make sure they
are plugged in tightly.
⑦ Please plug the rear camera interface when the camera is turned off. Do not frequently hot
plug the interface, which may cause damage to the camera. For details, please refer to the
following video: https://www.youtube.com/watch?v=CZYaV5Dh4ok
18
To Next Page
Loading...
