6
-7MAINTENANCE
1. Park the machine on a flat surface,
lower the implement and shut off
engine.
2. Check the fluid level on the fluid level
dipstick. If the level is too low, add
new oil to the prescribed level at the
oil inlet. (See "LUBRICANTS" in
Maintenance Section)
If oil level is low, do not run en-
gine.
(1) Oil Filler Plug (2) Gauge
(A) Oil Level is Acceptable Within This Range
CHECKING TRANSMISSION
FLUID LEVEL
IMPORTANT
(1) Oil Filler Plug (2) Gauge
(A) Oil Level Is Acceptable Within Range
CHECKING ENGINE OIL
LEVEL
S43O604AS43O603A
To avoid personal injury:
Be sure to stop the engine be-
fore checking the oil level.
When using an oil of different
make or viscosity from the pre-
vious one, remove all of the old
oil. Never mix two different types
of oil.
If oil level is low, do not run
engine.
IMPORTANT
!!
!!
!
CAUTION
1. Park the machine on a flat surface.
2. Check engine oil before starting the
engine or 5 minutes or more after the
engine has stopped.
3. To check the oil level, draw out the
dipstick, wipe it clean, replace it, and
draw it out again. Check to see that
the oil level lies between the two
notches. If the level is too low, add
new oil to the prescribed level at the
oil inlet.
(See "LUBRICANTS" in Mainte-
nance Section)
To Next Page
Loading...
