5
-26 DK90
Though the tire pressure is factory-set
to the prescribed level, it naturally
drops slowly in the course of time.
Thus, check it everyday and inflate as
necessary.
(A) Insufficient (B) Standard
(C)Excessive
INFLATION PRESSURE
Though the tire pressure is factory-set
to the prescribed level, it naturally
drops slowly in the course of time.
Thus, check it everyday and inflate as
necessary.
TIRES, WHEELS AND
BALLAST
WARNING
!!
!!
!
Do not use tires larger than speci-
fied.
Do not attempt to mount a tire.
This should be done by a quali-
fied person with the proper
equipment. Qualified persons
with the proper tire mounting
equipment should recognize the
following warning.
Never exceed 241 kPa (35 psi)
when attempting to seat a bead.
If beads have not been seated by
the time the pressure reaches 241
kPa (35 psi), deflate the
assembly, reposition the tire on
the rim, reduplicate and reinflate.
After seating the bead, adjust in-
flation pressure as recom-
mended in the inflation pressure
chart.
S43O530A
Classi-
fication
AG
AG
Tire Size
Inflation
Pressure
220Kpa, 32psi
2.3kg/cm²
138Kpa, 20psi
1.4kg/cm²
FrontRear
Maintain the maximum pressure in
front tires, if using a front loader or
when equipped with a full load of
front weights.
NOTE
12.4 24PR
18.4
34PR
To Next Page
Loading...
