6
-13MAINTENANCE
Do not operate the tractor imme-
diately after changing the trans-
mission fluid.
Run the engine at medium speed
for a few minutes to prevent dam-
age to the transmission.
IMPORTANT
1. To drain the used oil, remove the
drain plug at the bottom of the trans-
mission case and drain the oil com-
pletely into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with new KIOTI TF65 fluid up to
the upper line of the gauge.
(See "LUBRICANTS" in Mainte-
nance Section)
4. After running the engine for a few
minutes, stop it and check the oil
level again; add oil to prescribed
level.
5. Replace the oil filter at same time
when the transmission replace.
To avoid personal injury:
Allow engine to cool down
sufficiently, oil can be hot and
can burn.
!!
!!
!
CAUTION
Oil Capacity
19.55 U.S.gal. (74
)
CHANGING FRONT AXLE
CASE OIL
S43O617A
(1) Oil Filler Plug (3) Drain plug
(2) Oil Level Check Plug
S43O616A
(1) Gauge (2) Oil Filler Plug
(A) Oil Level is Acceptable Within This Range
1. To drain the used oil, remove the
right and left drain plugs and filling
plug at the front axle case and drain
the oil completely into the oil pan.
2. After draining reinstall the drain
plugs.
3. Add the recommended gear oil
though the oil plug.
To Next Page
Loading...
