6 of 12 2011-9-23
temporary remove the channel from the current active scan.
14. Public Address
Start/end the public address function. Press this button and the function will be
active. Press the PTT button and speak to the microphone so that you can hear
your voice through the external speaker. Press this button once again and
return to the normal user mode.
15. Home Channel Changes to the home channels.
16. Talkaround Switch the radio between talkaround and repeater mode.
17. Monitor momentary/
Call Cancel
Press this button, CTCSS, DCS, 2Tone/DTMF signaling is closed as setting,
release it and return the normal operation.
18. Monitor/Call Cancel
Press this button to trigger this function and the CTCSS, DCS, and
2Tone/DTMF signaling will be closed, so you can receive the signal that can't
be heard in the normal operation. Press this button again to return to the
normal operation. Press this button in the selective call state to quit such a
state.
19. Squelch off momentary/
Call Cancel
Hold this button to open the squelch. Loosen this button to return to the normal
operation. Press this button in the selective call state to quit such a state.
20. Squelch off/Call Cancel
Press this button to open squelch, press it again to return to normal operation.
Press the button in the selective call state to quit such a state
21. Emergency Alarm
Press the top button which programmed as Emergency Alarm, the emergency
tone could be sent as the set in program software, and the identity and
background sound could also be sent to your partners and system.
22. Call Button 1 Sends the DTMF/2Tone code assigned to call 1 key.
23. Call Button 2 Sends the DTMF/2Tone code assigned to call 2 key.
24. Call Button 3 Sends the DTMF/2Tone code assigned to call 3 key.
25. Call Button 4 Sends the DTMF/2Tone code assigned to call 4 key.
26. Menu Select /Enter To enter the menu mode or make menu selections.
27. Lone worker Enables Lone worker function
28. Scan List Edit
Press this button and the radio will enter the fast menu mode for scan list edit.
For details, see “Menu Operation”.
29.Backlight Select
Press the button, the backlight could be chosen among light for long time, dark
for long time, and light automatically.
30. FCS Enable system FCS scan function.
31. Zone 0 Scan
Press the button to add the present channel into the zone 0 scan list. If icon
is displayed on the screen, it means that that channel has been added. Press
the button again to delete the present channel.
Long time button: when the time to press the button is shorter than this time, enable the short button function, when
longer than this time, enable the long button function.
ON/OFF button press time: time to be set to turn on the radio.
Monitor/ Hook Detection: select the Hook or Desk Mic Monitor function.
５. Radio Call
５.1 Send Selective Call
A. Press “Menu Select/Enter” button to enter the menu mode.
B. Press
/ button until “RADIOCAL”.
C. Press
button to select “SEL CALL”.
D. Press
/ button until the required call list appears.
E. Press “PTT” button to send the selective call.
To Next Page
Loading...
Need help?
General
