Kirisun PT8100 User Manual

8 of 12 2011-9-23
B. Press / button until “UTILITY”.
C. Press
button for selection.
D. Press
/ button until the items you require are showed.
E. Press
button for select. The radio will show the current setup.
F. Press
/ button to show all items that can be set with this item.
G. Press
button to select this setup
H. Press
button to return to the previous operation.
Change the setup items in the following table as per the previous steps.
Items Selectable Setups Functions
Squelch Level
"SQL LEV "
SQL 0 ~ 9 Change the squelch level of the radio.
Transmission Power
"PWR LEV "
"PWR LOW "
"PWR MID ",
"PWR HI "
Select transmission power among high, medium
and low levels.
Backlight
"BACK LED"
“BLED OFF"
"BLED ON "
"BL AUTO "
Select among such modes of backlight as
“turnoff”, “normal turn-on” or “auto”.
MCU software version
display
"SOFT VER"
……
Eg．“R01.00”
Show the software version.
9. Scan
In order to receive the calls from many channels, the radio can be programmed to scan these
channels. At most there are 32 channels in each scan list. Each channel can use a scan list
together with others or alone. （Zone 0 is the special list, which can have 256 channels.）
9.1 Start/End Scan Function
You can press “SCAN” button directly or enable the scan through the menu. When the scan
function is started, if the revert channel function is not chosen in the parameter setting,
“SCAN” icon will display, or otherwise revert channel will display.
1. Enter the scan state through menu mode.
A. Press the “Menu Selection/Enter” button to enter the menu mode.
B. Press
/ button until “SYS SCAN”.
C. Press
button for selection.
D. Press
/ button until “SCAN ON?” or “SCAN OF?”
E. Press
button for select.
2. Use the scan button.
A. Press “SCAN” button to activate the scan function.
B. Press “SCAN” button again to disable the scan function.
9.2 Nuisance Delete
If a channel continuously generates noise or interference, press the button to remove this channel
from the scan list temporarily.
Note: the priority channel can't be removed and the last one in the scan list, either.
9.3 Edit Scan List
9.4 Add or Delete the Channels in the Scan List
A. Press the “Menu Selection/Enter” button to enter the menu mode.
B. Press
/ button until “PROG LST”.

Kirisun PT8100 Specifications

General

Brand	Kirisun
Model	PT8100
Category	Radio
Language	English