58
Oil Pressure Flt The unit has detected that the Oil Pressure sender has become open
circuit. Normally this indicates a faulty sender or broken wiring. The Oil
Pressure icon flashes. This will only shut down when the Oil System is
set to Sender.
Engine Temp Flt The unit has detected that the engine temperature has not risen to 50
degrees within the first 5 minutes of running or the temperature sensor
has shorted to common. Normally this indicates a faulty temperature
sender or broken wiring. The Temperature icon flashes.
High Canopy Temp The unit has detected a high canopy temperature. The canopy temperature
icon is lit.
Belt Broken The unit has detected a broken belt. The broken belt icon is lit.
User Message The user has detected an alarm associated with the user analog input
The following warning messages indicate potential problems. When a warning occurs, the message
associated with the warning is displayed. Warnings clear automatically when the warning condition is
cleared.
Message Cause
No Excitation Excitation voltage is low when engine is running. This indicates a probable
charging fault or broken belt. The battery Icon is lit.
Low Charge Volts Battery Voltage is below the charging voltage setpoint when the engine
is running. Indicates that the alternator is not charging the battery. The
battery icon flashes.
Under Voltage Battery Voltage is below the low battery setpoint. The battery icon
flashes.
Over Voltage Battery Voltage is above the high battery volts setpoint. This may be due
to a faulty regulator or battery charger. The battery icon flashes.
Trip Alarm The trip input is preventing the engine from starting. The trip input must
be deactivated followed by pressing the stop button to clear the condition.
Oil Lock Out The unit has detected that the oil pressure is above the oil pressure
alarm setpoint with the engine not running. This warning prevents the
engine from attempting to crank with the engine potentially running. This
may be due to a faulty oil sender or a very tight engine. This warning is
disabled if Oil Pressure Check before Cranking is set to Off. The Oil
Pressure icon flashes.
Tacho Lock Out The unit has detected that a speed signal is present with the engine not
running. This warning prevents the engine from attempting to crank with
the engine potentially running. This warning can sometimes be caused
by ripple generated by mains powered battery chargers. The speed icon
flashes.
Excite Lock Out The unit has detected that a Excitation is present with the engine not
running. This warning prevents the engine from attempting to crank with
the engine potentially running. This warning can sometimes be caused
by ripple generated by mains powered battery chargers. The Battery
icon flashes.
Scheduler Lock Out The scheduler want to exercise the engine, but is being prevent to do so.
This may be due to an alarm stopping the engine while the scheduler
was running it. It may also be due to changing from Manual mode to Auto
mode while the scheduler is active
To Next Page
Loading...
Need help?
General
