4.2 Final decommissioning of the unit
Insert unit key in key switch.
1. Turn unit key to position “0”.
2. Unplug the power plug.
3. Remove unit key.
4. Leave unit door open to prevent the formation of odours and
mould.
4.3 Putting the unit back into operation
Before recommissioning, clean and disinfect the unit
Ä
Chapter 8
‘Cleaning and disinfection’ on page 56.
1. Plug in power plug.
2. Insert unit key in key switch.
3. Turn unit key to position “1”.
ð
The Display shows the interior temperature.
4. Check target temperature and adjust it, if necessary
Ä
Chapter 6.2.1.2 ‘Displaying and changing the target tem-
perature’ on page 39.
Lead time of the temperature alarm!
The temperature alarm is active at the earliest when
the target temperature is reached, and at the latest
after two hours of unit operation.
5. When the unit has reached its target temperature, place the
chilled goods in the unit.
Final decommissioning of the unit
Putting the unit back into operation
Transport and decommissioning
Putting the unit back into operation
23.05.2023 Refrigerator/freezer LABO series 35
To Next Page
Loading...
