8. Release [Target temperature].
ð
The first three digits of the IP address have been
entered.
9.
Press [Min.] to select the next parameter .
10. Press and hold [Target temperature].
ð
The next digits of the IP address are displayed.
11. At levels L62 and L63 repeat steps 6 to 10 until the IP
address of the standard gateway has been entered com-
pletely.
12. Set key switch to “1” to complete your input.
ð
The IP address of the standard gateway has been set up.
Personnel:
n
System/network administrator (recom-
mended)
Materials:
n
Network cable (EIA/TIA-568 standard),
(included in the scope of delivery of PC-
KIT-NET)
Requirements:
n The TCP/IP module has been installed (
Ä
Chapter 1.7 ‘Addi-
tional unit components’ on page 19 and
“Assembly and con-
nection manual – PC-KIT-STICK/PC-KIT-NET”).
n The KIRSCH-DATANET software (version 5.0 or higher) has
been installed on the local PC or local network.
1.
Switch off the unit
Ä
Chapter 7.2 ‘Switching off the unit’
on page 45.
2. Unplug the power plug.
3. Remove the dust cover from TCP/IP output.
4. Insert the network cable in the TCP/IP output.
5. Connect the network cable to the network socket.
ð
The unit has been connected to the network.
6. Insert the power plug in the socket.
7.
Switch on the unit
Ä
Chapter 7.1 ‘Switching on the unit’
on page 45.
1. Insert unit key in key switch.
2. Set unit key to “P”.
Connecting the unit to the local
network
Reading out the MAC IP address on
the unit
Operation
Setting up PC-KIT-NET (optional)
23.05.2023 Refrigerator/freezer LABO series 53
To Next Page