CAUTION!
Danger of damage due to interrupted cooling chain
during stock transfer!
If the cooling chain of the chilled goods is interrupted by
a stock transfer, the prescribed storage conditions are
no longer met. This can damage the chilled goods.
– Do not subject chilled goods to light during the
stock transfer.
– Do not place chilled goods near radiators during the
stock transfer.
– Make sure that chilled goods are stored in the
replacement unit according to the specifications of
the relevant manufacturer.
Requirements:
n The chilled goods have been transferred.
n The unit has been switched off
Ä
Chapter 7.2 ‘Switching off the
unit’ on page 45.
1. Remove drawers and shelves.
NOTICE!
Danger of damage to the electrical system due to
unsuitable cleaning agents!
The unit contains sensitive electronic parts. If the elec-
tronic parts come into contact with unsuitable cleaning
agents, this can lead to a loss of function in the unit.
– Use cleaning agents free from sand and acid.
– Do not use chemical solvents.
– Do not bring cleaning agents into contact with elec-
trical parts.
2. Clean interior with warm water, dry it, and then disinfect it
with a suitable disinfectant (
Ä
‘Disinfectants’ on page 56).
3. Clean the drawers and shelves with washing-up liquid, dry
them and disinfect them with a suitable disinfectant (
Ä
‘Dis-
infectants’ on page 56).
4. Put drawers and shelves back in the unit.
5. Wipe the door seal only with clear water and rub until thor-
oughly dry.
6.
Switch on the unit
Ä
Chapter 7.1 ‘Switching on the unit’
on page 45.
Treat the housing with cleaning and care products for painted
surfaces.
Cleaning the housing
Painted housing
Cleaning and disinfection
23.05.2023 Refrigerator/freezer LABO series 57
To Next Page