NOTICE!
For repairs, contact the service department:
The following company is appointed and authorised by
KIRSCH to provide service for the unit:
Ä
‘Service con-
tact’ on page 4
CAUTION!
Danger of damage due to interrupted cooling chain
during stock transfer!
If the cooling chain of the chilled goods is interrupted by
a stock transfer, the prescribed storage conditions are
no longer met. This can damage the chilled goods.
– Do not subject chilled goods to light during the
stock transfer.
– Do not place chilled goods near radiators during the
stock transfer.
– Make sure that chilled goods are stored in the
replacement unit according to the specifications of
the relevant manufacturer.
NOTICE!
Meaning of “X” for error and status messages
X is not shown on the display.
– Instead, the display shows a number that describes
the relevant part.
Tab. 11: Error messages of the unit
Display Buzzer Description Measure
3
Sensor X:
n Error or short circuit in the relevant
sensor.
n The cryostat is running in the emer-
gency program.
n Contact the service department.
3
Sensor X:
n Error or break in the relevant
sensor.
n Cryostat is running in the emer-
gency program.
n Contact the service department.
3
Fan X:
n Speed of the fan in question is too
low.
n The temperature of the chilled
goods may fluctuate.
n Transfer chilled goods to a new
location.
n Contact the service department.
Status displays and error messages
Error messages
23.05.2023 Refrigerator/freezer LABO series 67
To Next Page
Loading...
