Important! (SINGLE MODELS ONLY)
The product may move. Mark chassis position on cavity.
4 SINGLE MODELS ONLY. Gently open the drawer and mark the
chassis position on the cavity, before removing the tub.
5 Open the drawer (Bottom drawer in DOUBLE MODELS).
Release the tub by depressing the right hand tub clip and pushing
it back 30mm. Repeat on the left hand side.
6 Lift the tub up off the drawer runners.
7 Slide both runners back into the product.
8 Place the tub onto the floor.
For SINGLE MODELS, depending on the height of the cavity, the
tub will need to be supported, eg. on a chair.
Step 2: removing the tub
To Next Page
Loading...
