16
9 - DOUBLE MODELS ONLY
Adjust the height of the product to suit the cabinetry, by turning
the feet from inside the product using a wrench or M5 socket.
TIP - Gently take the load off each foot using the slide and
then turn by hand.
NOTE: For integrated products, the upper panel may be aligned with
the top of the adjacent cabinetry, provided a minimum 5mm
clearance from the bench is maintained.
Important!
The product must be levelled to within 2.5mm from front to
back, and side to side.
Important!
The product should NOT support any part of the kitchen
cabinetry.
TIP - Place a spirit level on the drawer runners to level the
product.
Step 3: adjusting the feet (double models only)
To Next Page
Loading...
