2-7
5. To convert the gas distribution valve
for use with L.P. gas:
a)Pull the plastic cap off the gas distribu-
tion valve.
b)Unscrew the conversion cap from the
gas distribution valve and remove it and
the plastic cap. Note the difference be-
tween the L.P. and Natural gas ends of
the cap.
c) Install the loop on the plastic cap over
the natural gas side of the conversion
cap.
d)Install the plastic cap and the conver-
sion cap on the gas distribution valve
with the L.P. side facing up (you will see
“LP” stamped inside the cap, as shown
below).
6. Reinstall the storage drawer.
7. Turn the gas supply valve handle on.
Conversion Cap Set For
Use With L.P. Gas
L.P. Gas
Conversion Cap Set For Use
With (N) Natural Gas
Natural GasL.P. Gas
Plastic Cap
Gas Valve Handle To “On” Position
Plastic Cap
To Next Page
Loading...
