50
SOFT 80, SOFT 100 PELLET-BURNING STOVE
removal and/or reconstruction of related installations, or for any other ancillary intervention even if it is the result of works
to replace defective parts.
Klover S.r.l. shall not be held liable for any faults of the Product ascribable to external conditions and/or events including,
but not limited to, insufficient plant capacity, incorrect installation, lack of maintenance or maintenance not carried out in
accordance with the instructions appearing in the use and maintenance manual, or misuse of the Product. The cost of any
works will be borne by the Consumer in such cases.
Klover S.r.l. declines all liability for any damages that may be caused, directly or indirectly, to the Consumer and/or to a
third party or to persons, animals or property as a result of failure to comply with all the relevant instructions concerning
installation, use and maintenance of the Product. The injured party must prove the loss or damage, the defect and the
relative causal connection, and must notify the retailer from which the Product was purchased, pursuant to Legislative
Decree no. 24/2002.
7. Exclusions of the Klover Warranty
The Klover Warranty does not include:
• Defects to the Product not ascribable to manufacturing defects • Defects to the Product related to incorrect or
inappropriate installation • Defects related to improper operation of the flue • Defects to the Product caused by negligence,
accidental breakage, normal wear and tear, tampering and/or damage during transport (scratches, dents etc.), including
shipments sent free to destination, works carried out by unauthorised personnel and any additional damage caused by
incorrect interventions by the Consumer • Calibration of settings • Damages caused by the use of poor or inappropriate
fuel • Transport costs.
The Klover Warranty excludes the following Product components:
• Glass-ceramic or tempered glass, ceramic/majolica tiling and/or coated steel and/or cast iron. Changes in colour shades,
speckling, superficial cracking, shading and minor dimensional variations are not considered Product defects, but are
characteristics of the artisan manufacturing process • Painted, chrome-plated or gilded details, handles, ignition heaters •
All the external components of the Product on which the Consumer may intervene directly during use and/or maintenance,
or which may be subject to wear and tear and/or the rust build-up, or blemishes on the steel caused by aggressive
detergents, in particular the use of wood at a rate that exceeds the recommended hourly capacity, or the use of fuels that
were not recommended or were not included in the instructions • Refractory materials or vermiculite • The pellet brazier,
grille and cast iron cooking plate, the smoke deflector or flame separator, the seals, fuses or batteries in the Product’s
electronic system and any other removable component that may be subject to normal wear and tear • Electrical and
electronic parts found to be faulty as a result of non-standard electrical connections, natural disasters or voltage variations
other than the nominal variation.
8. Competent Court
The Court of Verona shall have sole jurisdiction in the event of disputes.
To Next Page
Loading...
